The 6iE custom background screen dimensions are 3 1/2 inches diagonally. However, image scaling is not required thanks to auto-scaling when you upload your custom background.
Miscellaneous questions
Adding insulation both under a slab and near its exposed edges reduces heat loss into the ground and allows the slab to heat more quickly, which lowers total operating costs.
A snow-melting system is most efficient when the slab is preheated. As a rule of thumb, a snow-melting system should start preheating for 1 -2 hours before the arrival of snow/ice.
Matter, previously known as Project Connected Home over IP (CHIP), is not compatible with Warmup thermostats at this time.
Are you wondering if you can install radiant heating around your pool? Unfortunately, this is not permitted by code. Read more here.
Click “Read More” for details.
If your heating system was installed on a concrete slab or over an unheated space and insulation boards were not used, it is possible that the heat loss into the subfloor will cause your floors to heat up more slowly and possibly not reach the target temperature. Click “Read More” for details.
The resistance for your mat or cable is calculated on the length of the heater. Shortening the heater would increase the resistance and thereby the temperature. The cable is expected to operate fine at slightly higher temperatures for a time, but it may put undue strain on the end-splice, which may then trip and eventually fail.
When applied, you will select a number and this percentage represents the number of minutes the heat will be on out of every 10 minute cycle. For example, if you select 60%, the heat will be on for 6 minutes, followed by 4 minutes of the system being off. Then, after the 4 minutes, it will activate again for 6 and so on. This will continue until your programmed heating period ends or until you manually turn off the heat.
If wire spacing and floor height isn’t consistent, your floor may not heat evenly. Click “Read More” for details.